6c3799f1-c13c-403e-ba9e-aa0fe8b5db4b 2 4 5 decimal

&[DATE] &[TIME] - &[FILENAME]

This information is not for modeller (not relevant)

t.cw 2 :

t.cφ 3 :

t.hinge 4 :

Support / Hinge

supports# 0 ft * 10 ft * 20 ft * 40 ft * 50 ft * 1121025 mat :

0=hinge, 1=pin support, 2= fixed (built in) support. Use hinge for cantilever Enter from 0' to end of beam -> left to right

If I understand correctly the FEM beam function, to create a "Fixed" support I need to have a t.cw and a t.cphi at the same position. Therefore I need to create a new matrix with an extra support "type" at the same position.

Create Supports length# supports# 1 supports# cols el supports# 11 el - 2 / : Support# 05 matrix : n 1 supports# cols range type# supports# 2 n el : pos# supports# 1 n el : t# t.cw type# 1 ≡ t.hinge type# 0 ≡ # type# 3 ≡ unknown cases : t# unknown ≡ unknown support type type# num2str at column n num2str concyat trace continue 21 line 0 if Support# Support# t# pos# 0 ft * 0.1 length# * 0.1 length# * 15 mat stack eval : 51 line for 41 line