Both projects show the same defect from Maple.
In their reinvention of the wheel, some developpers
forgot to make the wheel circular and forgot to add
the oiling plug. Could it be that Maple cheated Andrey
to acces the "working code".

These two projects are done from my side.
Mathematica outputs kilometers long solution,
What do they think ? That I'm a luggage without handle ?

I worked the all day on these two for closure,
trust me: I got a sun tan of these two reluctants

... all that said, very interesting.

cheers, Jean

---

Inst_TurboGen Signum.sm (90 КиБ) скачан 57 раз(а).

Hello Jean,

I would like that we would have had more users like you .

Regards,
Radovan

Hello Jean,

I would like that we would have had more users like you Good .

Regards,
Radovan
____________________________

Thanks Radovan, most appreciated.

To be more serious about these two projects, you must scrap them and reload
the last version [Saturday: October, 24, 22:48]. I finally got the twist
of compatibility Maple/Smath ... 1/1 Mathcad 11 ! It's true that the Maple
version Mathcad 8 ... 11 does not work like the Maple/Smath.
This type of stuff is specific to Control Engineering, but working with
Laplace is of general interest and skill to acquire .

Cheers: Jean

... the two promised working versions:
1. "TurboGen Smath" is directly applicable ,,, plug this/that =. bingo.
2. "TurboGen Signum" will have to be adapted to your project wrt the
range of of the 1rst segment and its juxtaposition to the 2nd one.

Enjoy, cheers, Jean

---

Inst_TurboGen Signum.sm (84 КиБ) скачан 61 раз(а).